

DIGITAL SOLUTIONS
Lightning and Transient Protectors
The SURGE Series of transient protectors consist of multi-stage devices which include three terminal gas discharge tubes, thyristor crowbar devices, and coordinating resistors.
Overview
Overview
Wiring, particularly long horizontal wiring, can convert transient electrical fields to destructive voltages at sensors and data logger terminals. Transient protection equipment can be used to divert these transients to ground, increasing installed system reliability.
The SURGE Series of transient protectors are capable of protecting against high-speed (100 volts per microsecond) transients of up to 20,000 amps, letting only 77 volts through before clamping to 4 volts. The protector is housed in a NEMA-4X enclosure or in a compact T35 DIN-rail housing with screw-terminal input/output and ground connection through the DIN rail, simplifying connections, and facilitating good signal practices: i.e. labeling, shielding, and routing outside cables away from protected lines.
In normal operation, the protector appears as a low resistor in series with each wire, typically having no effect on operation. During a transient, the 4 signal lines and up to 2 shield lines are clamped to ground. Once the transient is over, the device self-resets, allowing normal operation to resume. The protector is suitable for use with most devices, including vibrating wire sensors, data loggers, 4-20 mA transmitters, and other DC-powered sensors.
Product Features
- Low resistant in dormant state
- DIN-rail or NEMA-4X closure
- Compact, user-friendly design
- Protects against high speed (100V per microsecond) transients of up to 20.000 amps
- Self-resets for uninterrupted operation after transient has been completed
Features and benefits
Features and benefits
SURGE Series: Lightning and Transient Protector Specifications
| Item | Specification |
|---|---|
| Conductors Protected | SURGE 4D: 4+2 shields SURGE 4N: 4+1 shield SURGE 16N: 16+4 shield |
| Maximum transient current per line (1 event, 8/20 µs) | 20,000 Amps |
| Minimum conduction threshold voltage | 58 Volts |
| Peak pass-through voltage (common or normal mode) | 77 Volts |
| Output clamp voltage | 4 Volts |
| Series resistance per line | 1.6 Ohms |
| Maximum leakage current | 5 Microamps |
| Hold current | 150 Milliamps |
| Maximum AC current (1 line cycle) | 30 Amps RMS |
| Maximum continuous current | 2 Amps |
Resources
Resources
Related products

Digital Solutions
Cables
Contact an expert
Contact an expert
